Docomo prosolid II foma P851i, Manual

Page: 118 / 488

116
Quality
Alarm
Tone/Display/Light
Setting
When a call is liable to be disconnected midway because of bad radio wave conditions, an alarm sounds
to inform you right before possible disconnection.
Talk Quality alarm
・
No tone····················Does not sound.
・
High tone·················High alarm sounds.
・ Low tone ·················Low alarm sounds.
1
Incoming call Mail/Msg. ring time
・
Mail ············· For incoming i-mode mail and SMS messages.
・
Chat mail
・ MessageR
・
MessageF
1
ON/OFF
・
ON ··········Sets a ringing time.
・
OFF ········Ring tone, Vibrator, Call/Charging indicator, and Display Light do not work. (The setting is completed.)
2
Enter a ringing time (seconds).
●
Enter a two-digit number from “01” through “30”.
3
Sounding Alarm when a Line is Likely to be Disconnected
<Quality Alarm>
Menu 75
Setting at purchase
High tone
Setting Ringing Time for Mail and Messages R/F
<Mail/Message Ring Time>
Menu 68
Setting at purchase
Mail/Msg.ring time ·······ON
Ringing time·················5 seconds
You can set the duration of the ring tone which sounds for incoming
i-mode mail, SMS messages, Chat mail and Messages R/F.
You can set where you make the ring tone sound from for when you connect the Flat-plug
Earphone/Microphone Set with Switch (option). The alarm notification, and playback tone by Melody
Player will sound from where you set as well as the ring tone.
External option Earphone
・
ESpeaker ··················A tone sounds from both the earphone and speaker.
・
Earphone ··································A tone sounds only from the earphone.
1
Sounding Ring Tone from Earphone Only
<Earphone>
Menu 51
Setting at purchase
ESpeaker
● You might be disconnected without hearing an alarm if radio wave conditions deteriorate suddenly.
●
An alarm for “Quality alarm” sounds only from the earpiece during a video-phone call.
●
An alarm for “Quality alarm” does not sound during switching between a voice call and video-phone call.
Information
● When “OFF” is set, “ ” appears on the Stand-by display.
Information
●
Even when you select “Earphone”, the ring tone sounds from both the earphone and speaker about 20 seconds after ringing starts.
However, the ring tone sounds from the earphone only even after about 20 seconds elapses if you make it sound in other means
than receiving a voice call/video-phone call/packet, or alarm notification.
●
Even when you select “Earphone”, the tone sounds from the speaker when you do not connect the Flat-plug Earphone/Microphone
Set with Switch.
●
Do not wind the cord of the Flat-plug Earphone/Microphone Set with Switch around the FOMA phone.
●
The FOMA phone may pick up noise if you take the cord of the Flat-plug Earphone/Microphone Set with Switch close to the FOMA
phone during a call.
Information