Docomo FOMA P905ITV, Instruction Manual

Page: 54 / 596

52
V
o
ice/
V
id
e
op
ho
ne Cal
ls
The reason why it could not be connected is displayed. (The displayed reason might not
be the same as the actual reason depending on the type of the other party
’ s phone and
contract for network services.)
If a videophone call could not be connected
Messages Reasons
Check number, then
redial You have dialed a non-existent phone number.
Busy The other party is busy. (Depending on the receiver ’ s
phone, this message might be displayed during packet
communication as well.)
Busy with packet
transmission The packet communication is progress at the other end.
Out of service area/power
off The other party ’ s phone is out of the service area or turned
off.
Set caller ID to ON Your caller ID is not notified. (when dialing “visualnet”, etc.)
Your call is being
forwarded During forwarding
Redial using voice call The other party activates Call Forwarding Service but the
forwarding destination phone does not support videophone
calls.
Upper limit has been
exceeded
Connection failed The upper limit for the plan with the limit function (Type
Limit, Family Wide Limit) is exceeded.
Please make your call
from the i-mode web page You did not make a videophone call from the IP (Information
Provider) site among i-mode official sites (at dialing to
V-live).
Connection failed Redial after setting “Activate” of “Caller ID notification” to
“ON”.
This may appear in the case other than above.
If “Voice call auto redial” is set to “ON”, and a videophone call is not connected, a voice
call is automatically made.
≥
Videophone calls cannot be connected to the phones that do not support the
videophone function, or to the phones that are out of the service area or turned off even
if they are videophones. If you have set “Voice call auto redial” to “ON” and attempt to
dial a phone that does not have the videophone function, the number will be redialed
as a voice call. However, this operation might not work if you call the phone connected
with ISDN-synchronous 64K or the ISDN videophone that does not support 3G-324M
(as of January 200
8 ), or if you dial the wrong number. Note that you could be charged
for the communication.
≥
Once the videophone call has started communications, redialing as a voice call will not
be made.
Auto-redialing
Function Menu while Entering Phone Number
Function menu Operation/Explanation
Notify caller ID See page 46.
Prefix numbers See page 62.
Int’l dial assist See page 61.
Select image See page 77.
Multi number You can select a phone number to be notified to the other party.
(See page 426.)
Add to phonebook See page 94.
Compose message You can compose a mail message to send to the phone number
set as the destination address.
Go to step 3 on page 190.
Chaku-moji See page 57.