!
USER MANUAL – Release 1.2 of 01/01/2010
Page 73 of 191
Version: 02/03/2010
•
to indicate that the condenser fans are working
(in the case of AIR-AIR or AIR-WATER unit configuration)
If the alarms occur or particular working modes sub-enter, the following icons will be shown on the main
screens:
•
flashing to indicate that an alarm is active
•
to indicate that the UNLOADING mode is in progress
•
on to indicate that the defrost cycle is in progress, flashing during the count
•
to indicate that the anti-freeze/support heaters are active
•
automatic switch-off and/or energy saving is enabled during the current day
•
to indicate that the unit is working within the energy saving period or that the dynamic set-
point is active
Below find a typical screen during working in cooling mode:
16.3 SET KEY
To set the set-point of the cooling and/or heating from the main screen, press
SET
. In this way, enter the set-
point screen.
To modify the values, position the cursor on the element and press the
SET
key:
•
The element starts to flash.
•
Increase or decrease the value using the
UP
and
DOWN
keys.
•
Confirm the modification by pressing the
SET
key again.
