Dibo SBH-G-D, Original Instructions Manual

Page: 154 / 225

EN
MalFunCTIon TaBlE
DiBO 58
Malfunction table
at a possible malfunction one can consult the table mentioned below and if you
obtain on this basis no solution, we advise to contact a DiBo technician and/or
a recognized DiBo representative.
MALFUNCTION CAUSE SOLUTION
Machine does not start
• Electrical supply not connected
• net fuse defect
• Main switch on “0”
• Rest malfunctions • Connect the electrical supply
• Check net fuse
• put main switch on “1”
• Consult an expert
no water pressure
• To few water inlet
• Filter stuffed-up • Repair water inlet
• Clean/replace filter cartridge
Instable and to weak pressure
• air in water supply (leaks in water
supply)
• nozzle or lance stuffed-up or worn-
out.
• pressure regulator defect
• Rest malfunctions
• put machine completely without
power! Repair leaks in supply.
• Clean or replace
• Consult an expert
• Consult an expert
Water in product tank • non return valve in filter defect • Replace suction filter
no additions of products
• Suction pipe
• Suction filter stuffed-up
• product tank empty
• Spray pressure to high • Repair suction pipe
• Clean suction filter
• Refill or replace tank
• lower spray pressure
no hot water SBh-D
no hot water SBJ-G
• Main switch not on position “2”
• Burner switch not on position “1”
• heat resistors defective
• Temperature sensor defective
• Rest malfunctions • put main switch on position “2”
• put burner switch on position “1”
• Consult an expert
• Consult an expert
• Consult an expert
aerator does not turn
SBh-D
SBh-G
• net fuse defect
• Main switch not on position “2”
• Burner switch not on position “1”
• Electrical motor defective • Check net fuse
• put main switch on position “2”
• put burner switch on position “1”
• Consult an expert
Burner does not start
• no fuel
• rest malfunctions • Refill fuel
• Consult an expert
hp pump pulse
• leak or congestion in supply
conduit
• To much air present
• Clean/replace/repair
• De-aeration of cleaner