Dibo SBH-G-D, Original Instructions Manual

Page: 117 / 225

SERVICE
EN
DiBO 21
Service
GENERAL
all maintenance activities must happen at an disconnected machine and hoses
without pressure. Checking the electric components can happen exclusively by
an expert. Exclusively accessories and replacement components which have
been approved by the manufacturer can be used. Directly after the activities all
securities- and protection parts must be assembled, before the machine is put
in functioning. “a golden rule” that contributes to a perfectly working machine
with few problems, is well the following:
A daily control and cleaning of the machine frequently do wonders!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly
at regular times with a thorough maintenance. Therefore the experience and
the “know-how” of DiBo a technical good working machine is insured and
large maintenance turns can be carried out by experienced DiBo technicians
by means of appointment or maintenance contract, we can suppose in advance
that it is satisfied to these two points.
MAINTENANCE DIAGRAM
1
General
The user can carry out only those actions for which in this book authorisation
are given. Each other act has been prohibited! For the maintenance turns of
burner kettle, high pressure pump, combustion engines and of components
which have to do with the security, one must contact our DiBo technicians.
2
Preventive maintenance diagram
DISCRIPTION PERIOD
Control of the electric cables, high and low pressure
hoses and coupling and control of the oil level.
after each use
Refreshing pump oil. First 50 hours.
Cleaning water filter. Each 50 hours.
Replacement and cleaning fuel filters. Each 50 hours.
Cleaning fuel tanks. First 50 hours, each
following 200 hours.
all following refreshments of pump oil. Each 200 hours.
Extra control/replacement of joints, valves, o- rings
by acknowledged DiBo- technicians!
Each 600 hours.
3
Control of oil level and refreshing pump oil
Check for each use of the machine the oil with the oil level glass or with the oil
level bar. oil must stand right with the sign of the oil level glass, if the this case
is not, oil tops up until the sign. If oil looks forward to there milky, consult directly
the DiBo technicians. To refresh oil, as follows work goes:
• unbolt the drain plug below the pump.
• unbolt the tap with the oil level bar.
• Catch all oil in a barge and remove oil like further described in the guide.
• Force up the drain plug there and top up the oil in the breach to the upper
part to on the mark line.
• Force up the tap with the oil level bar there. Recommended oil: 1.836.042.
4
Cleaning of the water filters
Clean the water filters regular and remove possible dirt.
5
Cleaning fuel filters
Dismantle and clean the fuel filters, possibly replace. To empty the fuel tank.
Remove the drain plug and catch possible dirt in a barge. Rinse the tank with a
little bit off clean fuel and unbolt the drain plug.