Delta CT2000 Series, User Manual

Page: 153 / 634

Chapter 10 Digital Keypad

CT2000 Series
10-32
Warning Code
LCM Display * Description Corrective Actions
CE01
Comm Co mmand E r
Warning
Modbus function code error
Motor drive doesn’t accept the communication
command sent from keypad.
1. Verify if the keypad is properly connected to the
motor drive on the communication contact by a
communication cable such as RJ-45.
2. Press RESET on the keypad to clear errors.
If none of the solution above works, contact your local
authorized dealer.
CE02
Comm Address Er
Warning
Modbus data address error
Motor rive doesn’t accept keypad’s communication
address.
1. Verify if the keypad is properly connected to the
motor drive on the communication contact by a
communication cable such as RJ-45.
2. Press RESET on the keypad to clear errors.
If none of the solution above works, contact your local
authorized dealer.
CE03
Comm Data Error
Warning
Modbus data value error
Motor drive doesn’t accept the communication data
sent from keypad.
1. Verify if the keypad is properly connected to the
motor drive on the communication contact by a
communication cable such as RJ-45.
2. Press RESET on the keypad to clear errors.
If none of the solution above works, contact your local
authorized dealer.
CE04
Comm Slave Error
Warning
Modbus slave drive error
Motor drive cannot process the communication
command sent from keypad.
1. Verify if the keypad is properly connected to the
motor drive on the communication contact by a
communication cable such as RJ-45.
2. Press RESET on the keypad to clear errors.
3. Shut down the system, wait for ten minutes, and
then power on again the system.
If none of the solution above works, contact your local
authorized dealer.
CE10
KpdC om m Time O ut
Warning
Modbus transmission time-Out
Motor drive doesn’t respond to the communication
command sent from keypad.
1. Verify if the keypad is properly connected to the
motor drive on the communication contact by a
communication cable such as RJ-45.
2. Press RESET on the keypad to clear errors.
3. Shut down the system, wait for ten minutes, and
then power on again the system.
If none of the solution above works, contact your local
authorized dealer.
TPNO
TP No Ob ject
Warning
Object not supported by TP
Editor
Keypad’s TP Editor uses unsupported object.
1. Verify how the TP editor should use that object.
Delete unsupported object and unsupported
setting.
2. Reedit the TP editor and then download it.
If none of the solution above works, contact your local
authorized dealer.