Phone:
(844) LEDONE6 |
Fax:
1-510-217-9461 |
Web:
www.ledonecorp.com
`
APPLICATIONS:
This emergency driver can be used with most LED loads that have
a rated voltage of 25-48Vdc. These emergency packs have been
evaluated to and found compliant to UL 924. The emergency pack
assembly is accepted as a component of a luminaire where the
suitability of the combination shall be determined by UL or
authorities having jurisdiction. The as-installed performance of the
system must meet or exceed all Federal, State and local code
requirements.
FEATURES:
•
Selectable emergency power 10W, 15W and 20W
•
Constant output power (auto-sensing output within
each range)
•
Output class 2 complaint
•
Battery protection: over voltage protection, low voltage
protection, over temperature protection and short
circuit protection
DIMENSIONS:
OPERATION:
AC Operation:
AC power is present. The AC driver operates the lED
load (the LED load must be less than 100W) as designed. The
emergency pack is charging in a standby mode. The test button will
be lit showing that the battery is charging.
Emergency operation:
When the AC power goes out, the
emergency pack detracts the power outage and automatically
switches to the emergency mode. The LED load is illuminated for a
minimum of 90 minutes. When the AC power is restored, the
emergency pack switches back to normal mode and starts re-
charging.
Testing Procedures:
Press the test button to cut the power to the
AC driver and switch the system to emergency mode. Release the
test button to return to normal mode. Switch off the circuit
breaker to simulate a full power outage. For initial testing, allow
the unit to charge approximately 1 hour. Then conduct a short
discharge test. Allow a 24-hour charge before conducting a 1-hour
test.
NFPA 101 Life Safety Code outlines the following schedule:
Monthly
–
Ensure that the test button light is illuminated. Conduct
a 30 second discharge test by depressing the test button. The LED
load should operate at reduced output.
Annually
–
Ensure that the test button is illuminated. Conduct a
full 90-minute discharge test. The unit should operate as intended
for the duration of the test.
Page: 1 of 3
Emergency Driver 20W Spec
LOD-EXTED-M20W
