Dell PowerVault TL2000, User Manual

Page: 67 / 283

Attaching the Library to a Server
The 2U library and the 4U library can be attached to servers using the following
interfaces:
v SCSI (LVD Ultra 160)
v
Fibre Channel
v
Serial Attached SCSI (SAS)
Connecting the Host Interface Cable
To connect the host interface cables to the library:
1. It is recommended that you shut down and turn OFF the associated server.
Turn OFF all attached devices. Remove the power cables from the server and
all attached accessories.
Important: Failure to remove the power cords from these devices before
connecting the host interface cable could result in damage to the
library.
2. For a SCSI library, attach one end of the host interface cable to one of the
connectors on the back panel of the library (see
1
in Figure 4-13 on page
4-12). For a Fibre Channel library, attach one end of the host interface cable to
the connector on the back panel of the library (see
5
in Figure 4-14 on page
4-12). For a Serial Attached SCSI (SAS) connected library, attach the host end of
the SAS cable to the SAS HBA (see
2
in Figure 4-15 on page 4-12). Full high
drives will have dual SAS connectors. Half high drives will have one SAS
a77ug1
10
1
Figure 4-12. Securing the 4U library to the rack
Chapter 4. Installation and Configuration
4-11