90
| Configuring and Using Device Groups in AirWave
Dell PowerConnect W-AirWave 7.4
| User Guide
6. To configure settings specific to Proxim 4900M, locate the Proxim 4900M section and define the required
fields.
Table 64
describes the settings and default values.
7. To configure Symbol-only settings, locate the Symbol section and define the required fields.
Table 65
describes the settings and default values.
8. Select Save when radio configurations as described above are complete, select Save and Apply to make the
changes permanent, or select Revert to discard all unapplied changes.
802.11g Transmit Rate
Auto
Fallback
This setting specifies the minimum transmit rate required for the AP to permit a user
device to associate.
802.11a Transmit Rate
Auto
Fallback
This setting specifies the minimum transmit rate required for the AP to permit a user
device to associate.
Rogue Scanning
Yes
If enabled, any ORiNOCO or Avaya APs in the group (with the appropriate firmware)
will passively scan for rogue access points at the specified interval. This rogue scan
will not break users' association to the network.
NOTE: This feature can affect the data performance of the access point.
Rogue Scanning Interval
15 minutes
If rogue scanning is enabled, this setting controls the frequency with which scans are
conducted (in minutes). Frequent scans provide the greatest security, but AP
performance and throughput available to user devices may be impacted modestly
during a rogue scan.
Table 64
Groups > Radio > Proxim 4900M Fields and Default Values
Setting
Default
Description
4.9 GHz Public Safety
Channel Bandwidth
20
This setting specifies the channel bandwidth for the 4.9 GHz radio. It is only applicable
if you are running the 802.11a/4.9 GHz radio in 4.9 GHz mode.
802.11a/4.9 GHz Public
Safety Operational Mode
802.11a
This setting specifies if the AP will run the 802.11a/4.9 GHz radio in 802.11a mode or in
4.9 GHz mode. Please note that 4.9 GHz is a licensed frequency used for public safety.
Table 65
Groups > Radio > Symbol Fields and Default Values
Setting
Default Description
Rogue Scanning
Yes
If enabled, Symbol access points with 3.9.2 or later firmware in the group will passively scan
for rogue access points at the specified interval. This rogue scan will not break a user’s
association to the network.
Rogue Scanning
Interval (5-480 min)
240
If rogue scanning is enabled, this setting controls the frequency with which scans are
conducted (in minutes). Frequent scans provide the greatest security, but AP performance
and throughput available to user devices may be impacted modestly during a rogue scan.
Table 63
Groups > Radio > Proxim AP-600, AP-700, AP-2000, AP-4000; Avaya AP-3, Avaya AP-7, AP-4/5/6, AP-8;
ProCurve520WL Fields and Default Values (Continued)
Setting
Default
Description
Summary of Contents for PowerConnect W-Airwave
Page 1: ...Dell PowerConnect W AirWave 7 4 User Guide ...
Page 106: ...106 Configuring and Using Device Groups in AirWave Dell PowerConnect W AirWave 7 4 User Guide ...
Page 256: ...256 Creating Running and Emailing Reports Dell PowerConnect W AirWave 7 4 User Guide ...
Page 310: ...310 Index Dell PowerConnect W AirWave 7 4 User Guide ...
