44
| Configuring AMP
Dell PowerConnect W-AirWave 7.4
| User Guide
3. On the AMP Setup > Network page, locate the Static Routes area. This section displays network, subnet
mask, and gateway settings that you have defined elsewhere from a command-line interface.
4. Select Save when you have completed all changes on the AMP Setup > Network page, or select Revert to
return to the last settings. Save restarts any affected services and may temporarily disrupt your network
connection.
What Next?
Go to additional tabs in the AMP Setup section to continue additional setup configurations.
Complete the required configurations in this chapter before proceeding.
AirWave support remains available to
you for any phase of AirWave configuration.
Creating AirWave Users
AirWave installs with only one AMP user—the
admin, who is authorized to:
define additional users with varying levels of privilege, be it manage read/write or monitoring.
limit the viewable devices as well as the level of access a user has to the devices.
Each general user
that you add needs a
Username, a Password, and a Role. Use unique and meaningful user
names as they are recorded in the log files when you or other users make changes in AirWave.
The user
role
defines the user type, access level, and the top folder for that user. User roles are defined on the
AMP Setup > Roles page. Refer to the next procedure in this chapter for additional information,
“Creating
AirWave User Roles” on page
46
.
The admin user can provide optional additional information about the user including the user's real name, email
address, phone number, and so forth.
Perform the following steps to display, add, edit, or delete AirWave users of any privilege level. You must be an
admin user to complete these steps.
1. Go to the AMP Setup > Users page. This page displays all users currently configured in AirWave.
Figure 18
illustrates the contents and layout of this page.
Figure 18
AMP Setup > Users Page Illustration
Secondary
ntp2.yourdomain.com
Sets the IP address or DNS name for the secondary NTP server.
Table 20
AMP Setup > Network > Secondary Network Fields and Default Values (Continued)
Setting
Default
Description
NOTE: This section does not enable you to configure new routes or remove existing routes.
NOTE: Username and password are not required if you configure AirWave to use RADIUS or TACACS authentication. You do not
need to add individual users to the AirWave server if you use RADIUS or TACACS authentication.
Summary of Contents for PowerConnect W-Airwave
Page 1: ...Dell PowerConnect W AirWave 7 4 User Guide ...
Page 106: ...106 Configuring and Using Device Groups in AirWave Dell PowerConnect W AirWave 7 4 User Guide ...
Page 256: ...256 Creating Running and Emailing Reports Dell PowerConnect W AirWave 7 4 User Guide ...
Page 310: ...310 Index Dell PowerConnect W AirWave 7 4 User Guide ...
