![background image](http://html1.mh-extra.com/html/daum-electronic/8008-trs/8008-trs_user-manual_514128087.webp)
M 8
CS-1
CS-1
GS
GS
3
3a
2
2
CS
3
2b
3
3
3
A
B
A
A
B
B
Fig. 2
Fig. 3
Fig. 1
CS-1
3
Mounting the handle column
Inserting the adjustable handle column
in the frame
Required tools:
Allen key SW6
Insert carefully the preassembled handle column (2), with
the telescopic tube first, into the opening of the front frame tube.
Take special care to avoid jamming the dashboard cable (3),
which is protruding at the lower end of the column. The position
holes of the telescopic tube must be pointing to the back, to
the toggle button (2b), to allow the button to engage into one
of the holes. The connector (CS-1) of the dashboard cable (3)
must protrude out of the lower part of the frame tube when
the handle column is inserted in the frame tube until it stops.
The fastening screw (2a) can be used to immobilise the handle
column. This screw must be tightened very firmly after the fine
tuning (see page M14 - handle height).
The adjustable handle column (2) consists of 3 main segments
connected by articulated joints. This allows to freely adjust the
height, the distance to the saddle, and the inclination of the
dashboard (3) with the handle (7).
Pull a short piece of the dashboard cable (3) from the frame
tube (bottom) and feed it between the square frame tubes.
Then connect the connector (CS-1) of the dashboard cable (3)
with the connector (GS) the base cable (3a) (Fig. 3). Then
push back the cables with the connectors and hide them
in the frame.
Upper segment
Middle segment
M8 recessed head screw
M8 recessed head screw
Telescopic tube
Position holes
Joint B
Lock wedge B
Stop screw
Joint A
Clamp slot
Holes
for the clamp
Lock wedge A
(with M8 screw)
Cable clip
The joints A and B are fastened by mean of an M8 recessed
head screw to the side (tensing screw), and from the front
side by mean of special lock wedges (A and B - M8 recessed
head). To adjust the angle of the
fastening of the joint using the supplied
SW6 Allen wrench, adjust the joint to the required angle,
and retighten the fastening firmly (see also page M14).
You must regularly check the tightening state of the joint
fastening, and retighten them when needed.
dashboard support, you must
first release both
Angle and articulated joint setting of the handle column
2.
2.
1
2.
2
2.
3
Adjustment examples of
the handle column
2a
Frame tube
Assembly
Summary of Contents for 8008 TRS
Page 1: ...8008 TRS ...