![background image](http://html1.mh-extra.com/html/daum-electronic/8008-trs/8008-trs_user-manual_514128089.webp)
M 10
7c
7b
7
7d
7c
7c
4.1
8.1
LS1
LS2
Set
Fig. 3
Arm Rests / Wrapping the Handlebar Tape
Wrapping the racing handlebar
The included handlebar wrapping tape (7a) is used to wrap the handlebar (7) to provide a better hold
and adequate sweat absorption material.
Wrap the other side of the handlebar in the same way
(only in the opposite direction). Insert the end
caps into the tube extremities of the handlebar,
pushing the overhanging tape ends into the tube.
Wrapping should start at each end of the handlebar. Follow the indicated wrapping direction (see fig. 1)!
Press the beginning of the handlebar tape (7a) onto
the bar end with the sticky side down. A narrow strip
should protrude from the tube. Push this strip inside the
handlebar tube (7) with the end cap.
Secure the other end of the handlebar tape (after
cutting any excess length) with adhesive tape to
prevent it from unwinding.
Fig. 1
Wulst
Wrapping limit
(mark)
Fig. 2
Remove the
protective sheet
Fig. 4
Wrapping
direction
Attach the tape ends
with adhesive
tape!
Fig. 5
4.
1
4.
2
4.
3
4.
3.
4
Arm rests
(cushioned pads)
Fastening screws
with washers
and nuts
7
7a
7a
7a
Special cushioned armrests (7c) are supplied to ensure a comfortable arm rest when using the triathlon
handle add-on (7b). These pads are designed to fit on the corner curvature of the handle add-on (7b).
The elastic tongues (LS1/LS2) of the cushioned pads must be fastened with the special screws (7d).
You must use the supplied screws with their appropriate washers. Otherwise, the screw head will
thrust too deeply into the cushioning. We recommend mounting the arm rests after the dashboard is
mounted (see pages M11 & M12) since they could hinder you while mounting the dashboard.
Assembly
Summary of Contents for 8008 TRS
Page 1: ...8008 TRS ...