![background image](http://html1.mh-extra.com/html/daum-electronic/8008-trs/8008-trs_user-manual_514128090.webp)
M11
H/J
H/J
C/D
E
6a
3
2
CS
6
6x
CS
2
7
4.1
3
8a
C
C
D
D
X
X
HS
HS-2
CS
CS-2
HK2
HK1
3
8
8a
8b
7
6
7
8.1
4.1
Fig. 5
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Mounting the dashboard
5.
2
5.
3
The dashboard unit (4.1) is preassembled with the carrier plate (5),
the clamp (8.1) attached to that plate, and the handle (7) with
the handle add-on (7b). First insert the clamp (8.1) into the slots
at the upper end of the column (2), without fastening, to position
the whole unit. You might need to exert some pressure to insert
the rear tongue (8a) of the clamp because of tolerances.
You should take special care to avoid jamming the cable (3)
on the outside of the handle column (2)! We recommend
attaching the cable to the upper part of the column with
an elastic band or adhesive tape
(see X).
You may only release the handle (7) after you have tightened
both of the M8 recessed head screws (C), with their washers (D),
in order to secure a stable stand on the column (2). Unscrew
the front screw (8b) attaching the add-on set (7b) to the racing
handle (7) until the handle (7) starts moving freely and can be
adjusted to an approximate position. The final adjustment will
be done later.
Plug the black connector (CS) of the dashboard cable (3)
into the corresponding black socket (CS-2) on the circuit
board (within the lower opening in the housing and
the protective plate). Then plug the white connector (HS),
which is attached to the two wires HK1 & HK2 of the hand
pulse sensors, to the corresponding white socket (HS-2)
within the same opening in the housing.
Pos. A
Phillips screwdriver (not supplied)
Standard screwdriver (not supplied)
The dashboard holder (6) with its inner ring (6x) must
be fitted onto the handle column (2) before it is possible
to mount the dashboard (4.1) with the racing handle (7) on
the handle column (2). Both parts can simply be left loose at
the bottom of the column for the moment. (See position A)
Allen wrench SW5
5.
1
Parts needed:
Dashboard with the racing handle (7),
Triathlon handle add-on (7b),
protective plate (5) and clamp (8.1)
Dashboard support (6) with inner ring (6x)
tensing lever (6a) and appropriate washer (E)
2 recessed head screws with washers ( C/D )
2 fastening screws with washers ( H/J )
Tools needed:
pre-assembled
dashboard unit
5.
Assembly guide / Mounting the dashboard
Assembly
Summary of Contents for 8008 TRS
Page 1: ...8008 TRS ...