7e-1
?
7b
7e
7e-1
K
L
M
K
7
K
7b-L
7b-R
L
L
HS
HK1
HK2
M 9
Mounting steps
Join the upper and lower parts of the triathlon holder (7e) together around the handle tube (7),
either with or without the spacer sleeves (see above), and fasten them with an M8 screw (K),
with washer, and appropriate nut, at first without tightening. Mount the second holder (7e) in
the same way, also without tightening, at a distance of about 230 mm (from the centre of
the threaded hole of the holder 7e) over the centre of the handle (7).
Then you can install the preassembled triathlon handle. Position the left and right fastening tongues
(7b-R / 7b-L) above the holders (7e) so that you can screw the M8 screws (L) with washer in
the nuts (M) that are located in the shaft of the holders (7e).
Adjust the angle of the triathlon handle add-on (7b) to your personal needs (see page 14/15),
and to fit with the dashboard (4.1), with the racing handle (7), and also with the articulated joints
setting of the handle column(2). Afterwards, you should tighten all the screws firmly.
3.
1
3.
2
3.
3
See chapter 4 - Assembling the dashboard - for the connection of the hand pulse connector (HS)
Mounting the Triathlon Add-On Set
The supplied spacer sleeves (7e-1) are used to
compensate for the handle thickness when mounting
the triathlon-set holder (7e). If the holders are mounted
on the handle with wrapping tape (7a - see wrapping
the handle with the tape on page M10), then the spacer
sleeves will not be needed. If the holders (7e) are
mounted directly on the handle (7), then the
compensation sleeves (7e-1) are needed for the proper
fastening. In this case the wrapping tape (7a) will
be installed later.
Fig. 2
Handle tube
(
)
Racing handle
Spacer sleeves
(parts)
Fig. 1
Triathlon support
3.
Required tool:
Allen wrench SW6
Mounting the triathlon add-on set
7e
7e
Assembly
Summary of Contents for 8008 TRS
Page 1: ...8008 TRS ...
