![background image](http://html1.mh-extra.com/html/daum-electronic/8008-trs/8008-trs_user-manual_514128086.webp)
C.1
1a
1
2 / 2a
3 / 3a
C
15
2a
2a
er
go
b
ik
e
ergo
bike
M7
Moving position
Moving position
The rear standard feet (2a) are equipped with roller casters to ease moving the ergometer. When the
swing feet
are installed, (left SF/right SF) the device must be raised to a relatively steep angle
(approx. 75 /Fig. D) to bring the roller casters in contact with the floor. Without
swing feet
raising
the frame to an angle of approx. 15 (Fig. D.1) is enough.
(without
"Swing feet"
)
(with
"swing feet"
)
D
D.1
The
swing feet
(right SF and left SF/Fig. C) are attached to
the feet from underneath. The pins of the plastic feet (3/3a)
must engage in the corresponding holes (1a) of the support
feet (1) below the standard feet (2/2a). The adjusting pin of
the front standard feet should be completely screwed in.
Otherwise, the swing feet cannot snap into place.
ergo_bike
swing effect feet /
Assembly
The
swing feet
can be removed by simply pulling them out
or by giving them a sharp rap, provided they are only
snapped in position.
When using the
ergo_bike
without the
swing feet
on an uneven floor, use a screw driver to adjust
the pin of the front standard feet (see fig C.1) to
achieve an even stand.
left SF /
right SF
"swing feet"
Screw
It is possible to attache the
swing feet
with screws
(approx. 4.5x30mm) to improve the stability.
Frame
(lifted to approx. 15 )
Frame
(lifted to approx. 75 )
"swing feet"
front
foot
with floor
level adjustment
Assembly
Description
approx. 75
Summary of Contents for 8008 TRS
Page 1: ...8008 TRS ...