![background image](http://html1.mh-extra.com/html/daum-electronic/8008-trs/8008-trs_user-manual_514128095.webp)
16a
16a
16b
16b
14
15
18
18a
M 16
Mounting the Drinking Bottle & the Pedals
Mounting the drinking bottle
Needed tool:
Phillips screwdriver
The front frame tube has two threaded holes intended
for the screws used to mount the drinking
bottle holder (18a).
Mounting the pedals
Required tool:
15 mm wrench
Adjusting the pedals
Use the supplied phillips screws to mount
the bottle holder (18a).
Screw the pedal marked with an
“L”
(16a) to the pedal rod on the left side (15), and the one
marked with an
“R”
(16b) to the pedal rod on the ride side (14) of the bike when facing forward.
To avoid damaging the thread, you should start
screwing the pedals in place by hand, and
then tighten them very firmly using the wrench (15 mm).
Warning! Damage to the thread of the pedal rods is not covered by the warranty!
The threads of the pedal rods are compatible with those of standard bikes. Consequently, you can
install any pedal of the commercially available various pedal types as needed.
Refer to the setting instructions included with the pedals.
Warning!!
The left pedal (16a) has a left-hand thread, and must therefore be screwed
in place by turning it counterclockwise.
The right pedal (16b) has a right-hand thread and must therefore be screwed
in place by turning it clockwise.
You must tighten the pedals and pedal-rods screws
(under the pedal rod plastic cap)
after running
a distance of about 100 km, and then every 500 km!
clockwise
counterclockwise
Turn pedal
right
left
Pedal rods
Pedal rod attaching screw
and pedal rod plastic cap
R
L
10.
11.
Hinweis:
If the threaded holes of the dashboard column do
not correspond to the holes in the holder, you can
adjust the holder by sliding its lower part to adjust
the distance between the holes to the correct value.
Then simply put the drinking bottle (18) in the installed holder.
Assembly
Summary of Contents for 8008 TRS
Page 1: ...8008 TRS ...