xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
23
Figure 2-19 PoE System Settings window
The following parameters can be configured:
Parameter
Description
Unit
Select the unit you wish to configure. Tick the
All
check box to select all units.
(EI and
SI Mode Only)
Power Limit (37-
760)
Sets the limit of power to be used from the Switch’s power source to PoE ports. The user
may configure a Power Limit between 37W and 760W for the DGS-3120-24PC and
DGS-3120-48PC. The default setting is 760W.
Power Disconnect
Method
The PoE controller uses either
Deny Next Port
or
Deny Low Priority Port
to offset the
power limit being exceeded and keeps the Switch’s power at a usable level. Use the drop
down menu to select a
Power Disconnect Method
. The default Power Disconnect
Method is
Deny Next Port
. Both Power Disconnection Methods are described below:
Deny Next Port
– After the power limit has been exceeded, the powered port with the
highest port number will be denied, regardless of its priority. If Power Disconnection
Method is set to
Deny Next Port
, the system cannot utilize out of its maximum power
capacity. The maximum unused watt is 19W.
Deny Low Priority Port
– After the power limit has been exceeded, the next port
attempting to power up causes the port with the lowest priority to shut down so as to
allow the high-priority and critical priority ports to power up.
Legacy PD
Use the drop-down menu to enable or disable detecting legacy PDs signal.
Click
Apply
to implement changes made.
PoE Port Settings
To view the following window, click
System Configuration > PoE > PoE Port Settings
, as shown below:
Summary of Contents for xStack DGS-3120 Series
Page 1: ......
