44 – Cricket Robot Documentation
Install the PC Board Mounts
Find the 4 PC Board mounts (N). The parts are used to mount the Arduino controller. The
mounts have a small ridge on the notched end that slides into 4 slots on the body (A). Be
sure to note the orientation of these mounts as they can be installed backwards. File or
sand the ridge off and dry fit them into the matching notches on the body (A) before gluing
them. IMPORTANT: The motor mounts (N) must be installed on the opposite side of the
body (A) as the center beam (F & G) was installed on.
File or sand the ridge so that the
mount (N) can slide easily into its
matching pocket. Dry test fit the
mounts in the 4 locations noted.
Apply a small amount of glue to
each side of the tab and press
the mount into place. Make sure
it is fully seated and that the
small hooks point inward
Summary of Contents for Arduino Walking Robot
