. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
10-22
Server Management
Writer: Project: Server Management Comments:
File Name: N-ch10.doc Last Saved On: 4/23/96 11:31 AM
Table 10-5
Compaq System Configuration Utility
Remote Option Settings for Booting into Compaq Utilities
Option
Setting
Description
Network status
Enabled
To allow network access to Compaq Utilities, set
Network Status to Enabled and make sure the
Reset Boot option is set to Boot Compaq Utilities.
Network
protocol
To use IPX network access, set Network Protocol
to IPX. When the system restarts to the Compaq
Utilities because of an ASR reset, it will load IPX
network support. This will enable remote access
via NVT.
To use IP network access, set Network protocol
to IP. Also make sure to set Network IP address,
Network IP net mask and Network IP router
address. When the system restarts to the
Compaq Utilities because of an ASR reset, it will
load IP network support. This will enable remote
access via Telnet.
NOTE: The Network Status must be set to
Enabled for network access.
Network
controller
Compaq
Select the network controller type - choices are
Compaq and Custom. Select Compaq for the
NetFlex-2 ENET-TR Controller and the
NetFlex-TR Controller.
continued
