NOTE: The I/O connector cover, Automobile Adapter door, and hard drive
compartment door are available in the Doors Kit (Table 3-9).
4.20 PCMCIA Compartment Door
The PCMCIA compartment door comes installed on the computer base enclosure.
The door and spring are also available separately in the Doors Kit
(Table 3-9).
Removing the PCMCIA Compartment Door
To remove the PCMCIA compartment door, complete the following steps:
1. Open the door.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid possible damage to the PCMCIA connector or cards, be sure that all
PCMCIA cards have been removed before removing the PCMCIA compartment door.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
2. Carefully flex the door near the front [1] (Figure 4-54) to release the
hinge from the computer base enclosure.
3. Carefully flex the door near the rear [2] to release the hinge and
spring from the computer base enclosure (Figure 4-54).
Summary of Contents for LTE Elite
