E-3
SMART-2DH Array Controller Reference Guide
Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002
File Name: L-APPE.DOC Last Saved On: 2/27/98 12:06 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
3
2
1
Figure E-1.
Removing Array Accelerator Board from the SMART-2DH controller
WARNING:
Do not abuse, recharge, disassemble, dispose of in
fire or heat above 90
C, incinerate, or expose to water or fire.
Disposal of the batteries or Array Accelerator module should be
accomplished within compliance of local regulations or returned
to Compaq Computer Corporation by established parts return
methods.
Array Accelerator Installation
To install the Array Accelerator board on the SMART-2DH Controller:
1. Carefully align the connectors and plug the Array Accelerator board
onto the SMART-2DH Controller (1). Be sure the connectors are fully
mated by squeezing the boards together at the connector side.
2. Align the plastic standoff on the Array Accelerator board with the slot
in the SMART-2DH Controller board. Push it through and rotate the
top of the standoff 90
to lock the board in place (2).
3. Align the plastic stabilizing bracket with the holes on both boards,
ensuring that the mated boards will fit between the lips on the bracket.
Push the bracket in place until the detents snap through the holes (3).
