Eclipse
|
Upgrade Guide
Page 95
•
Auto-Disconnect
is selected (checked).
•
Download File Area
has
User Area
selected (checked).
•
The
Download File
radio button is selected.
6)
Select
‘…’
for the
User area
and select the appropriate MVX code file from the
Eclipse HX v9.1 software USB. According to your requirements, select
one
of the
following:
•
Drivers USB > ECLIPSE DRIVERS > PiCo-HX_PiCo_E-32 > xxxxxx-
MVX Boot
Where
xxxxxx
represents the product number. The folder contains the
*.mot
file and a
Read Me
file (
*.txt)
with version information.
•
Drivers USB > ECLIPSE DRIVERS > PiCo-HX_PiCo_E-32 > xxxxxx-
MVX Combined Boot & App
Where
xxxxxx
represents the product number. The folder contains the
*.mot
file and a
Read Me
file (
*.txt)
with version information.
7)
Upgrade / program the
first
of the two H8 devices:
a.
Connect the MVX serial cable (
CAB-MVX-48Z)
between the COM port on the
PC and
J9 (H8FP1)
on the MVX card.
Note:
The MVX connection is polarized to ensure correct connection.
b.
On the MVX card, ensure that jumper
H8 Boot1 (JP8)
is made.
c.
Select Program Flash from the Flash Development Toolkit (FDT) program.
d.
Confirm that FDT reports the image has been written successfully.
e.
Remove the serial cable.
f.
Remove jumper
JP8
.
For the location of connectors, jumpers and reset switch positions on the Eclipse
HX-PiCo, see
Figure 6-14: Eclipse HX-PiCo main board.
Note:
If the MVX card fails to upgrade, press the
Reset
button, located near the
J9 (H8FP1)
connector and select Program Flash from the FDT again.
If you are using a USB-to-serial adaptor, the adaptor may have to be unplugged
and re-plugged to enable the upgrade to start on some computers. If you are
running the EHX application, ensure that EHX is configured for Ethernet and not
serial connection.
8)
Upgrade / program the
second
of the two H8 devices:
a.
Connect the MVX serial cable (
CAB-MVX-48Z)
between the COM port on the
PC and
J11 (H8FP2)
on the MVX card.
Note:
The MVX connection is polarized to ensure correct connection.
b.
On the MVX card, ensure that jumper
H8 Boot2 (JP10)
is made.
