EXTender 1100A Switch and Remote Module System Administrator’s
Guide
92
APPENDIX B: R
EGULATORY AND
C
OMPLIANCE
Compliance and Regulatory Statements
EN55022 and CISPR22 Statement
This is a Class B product.
FCC Part 15 Statement
This digital equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
FCC Part 68 Statement
Models E-1100A
Equipped with the Analog port, this equipment complies with Part 68 of the FCC Rules
and the requirement adopted by ACTA of the United States.
On the product nameplate located on the bottom of the equipment is a label that contains,
among other information, a product identifier in the format US:AAAEQ##TXXXX.
If requested, this number must be provided to the telephone company.
Connection to the Telephone Line
This equipment uses RJ11C jacks for connection to the telephone line. You must, upon,
request, provide the following information to your local telephone company:
USOC Jack
type: RJ11C
.
This equipment cannot be used on the public coin telephone service provided by the
telephone company. Connection to party line service is subject to state tariffs.
Your telephone company may discontinue your service if your equipment causes harm to
the telephone network. They will notify you in advance of disconnection, if possible.
During notification, you will be informed of your right to file a complaint to the FCC.
Occasionally, your telephone company may make changes in its facilities, equipment,
operation, or procedures that could affect the operation of your equipment. If so, you will
be given advance notice of the change to give you an opportunity to maintain
uninterrupted service.
Document Number: M-1100A-MUC
Version: Rev AG
© Copyright 2008 Citel plc All Rights Reserved
