EXTender 1100A Switch and Remote Module System Administrator’s
Guide
57
Advanced IP Parameters – LAN Address
Prior to the administrator having remote access to the Switch Module and Remote Module
the system IP parameters must be configured. The following is a detailed description of
the programming areas that would be considered “essential” to the proper operation of the
Switch Module and Remote Module. The Remote Module LAN Address configuration
screen is shown below:
Path:
Remote->Configuration->IP->LAN->Address
TMI Path:
(Remote Only)->Set Config->IP Menu
Figure 32: Remote Module – LAN Address Configuration Screen
1. Setting
the
Address Mode
– In Static mode the Remote Module will use the IP
information entered in the Address, Subnet Mask and Default Router fields. In DHCP
mode (Dynamic Host Configuration Protocol), if the corporate network is equipped
with a DHCP server, the address will be assigned automatically. The unit’s IP address
is displayed with the system information (
Path:
Remote->Status->System->General
Info) and can be viewed at any time.
2. Configuring the unit’s IP
Address
– A valid IP address for the Remote Module must
be entered in order for it to operate on the IP network. The IP address should be
obtained from the corporate IT Administrator prior to configuring the Remote Module.
3. Configuring
the
Subnet Mask
- A valid subnet mask for the Remote Module must also
be entered in order for it to operate on the IP network. The subnet mask should be
obtained from the corporate IT Administrator prior to configuring the Remote Module.
4. The
Default Router
– A valid default router address must be entered to reach IP
hosts not on this same IP sub-network. The default router should be obtained from the
corporate IT Administrator prior to configuring the Switch Module.
Document Number: M-1100A-MUC
Version: Rev AG
© Copyright 2008 Citel plc All Rights Reserved
