19
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter Restrictions and Caveats in Cisco IOS XE 3.6S Releases
Caveats in Cisco IOS XE 3.6S Releases
Workaround:
In order to achieve marking and policing at the ingress we can use a conditional
policer but this is not supported at the egress.
•
CSCtx60094
Symptoms:
Type 1 MVPN routes are not created.
Conditions:
This issue is observed when the IP address of a loopback interface is changed.
Workaround: Create a dummy neighbor under the
address-family ipv4 mvpn
configuration or the
address-family ipv6 mvpn
configuration. Alternatively, unconfigure and reconfigure the MDT
group under the VRF configuration.
•
CSCtx73691
Symptoms:
Standby gateway starts forwarding packet for some of the HSRP sessions.
Conditions:
This is seen on flapping the HSRP session.
Workaround:
There is no workaround.
•
CSCtx75877
Symptoms:
ICMP unreachable messages are sent even though route for destination ip is present in
routing table. There is no ACL applied on any of the interface.
Conditions:
This is seen on reload with VRRP configuration present on incoming interfaces.
Workaround:
There is no workaround.
•
CSCtx77233
Symptoms:
The router displays an error message similar to the following:
FMFP-3-OBJ_DWNLD_TO_CPP_FAILED: SIP0: fman_fp_image: frr 0x1029 download to CPP
failed
Conditions:
Occurs when you shut down a backup tunnel and shut down an FRR-protected
interface, disabling TE tunnels.
Workaround:
None; the error does not impact traffic forwarding.
•
CSCtx75877
Symptoms:
ICMP unreachable messages are sent when a route for the destination ip address exists
in the routing table. There is no ACL applied on any of the interface.
Conditions:
Occurs under the following conditions:
–
There is a VRRP configuration applied to incoming interfaces.
–
There are not ACLs applied on any interface.
–
Your reload the router.
Workaround:
There is no workaround.
•
CSCtx77233
Symptoms:
The router displays an error message similar to the following:
FMFP-3-OBJ_DWNLD_TO_CPP_FAILED: SIP0: fman_fp_image: frr 0x1029 download to CPP
failed
Conditions:
Occurs when you shut down a backup tunnel interface and a FRR-protected interface,
bringing down MPLS TE tunnels.
Workaround:
There is no workaround; the error does not appear to impact traffic forwarding.