40
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
Open Caveats—Cisco IOS XE Release 3.7(2)S
This section documents the unexpected behavior that might be seen with the Cisco ASR 903 Router in
Cisco IOS XE Release 3.7(2)S.
•
CSCts95896
Symptoms:
The router stops passing traffic on EVC interfaces.
Conditions:
Occurs when you issue the default interface command and immediately restore the
configuration. The issue occurs with configurations containing either a large number of EFPs or
features that impact EFP programming at a lesser scale, such as QoS.
Workaround:
Wait for the router to clear the old EFP configuration before adding a new
configuration.
•
CSCty30951
Symptom:
The router displays the following console error message:
%QOSMGR-3-OUT_OF_TCAM_RESOURCES: SIP0: nile_mgr: Out of tcam resources to execute
command
Conditions:
Occurs when you remove a QoS configuration by setting the interface to the default
configuration.
Workaround:
There is no workaround.
•
CSCty34054
Symptom:
The router displays CPU utilization traceback messages and drops all multicast traffic
for 2050 seconds.
Conditions:
Occurs under the following conditions:
–
Multicast is enabled with more than 500 multicast groups.
–
The router is using RSP1B in SSM mode.
–
BDI is configured on the access side of the router.
–
There are 24 EFPs on each bridge domain.
–
You enter a
shutdown
command on the access interface.
Workaround:
There is no workaround.
•
CSCty76744
Symptom:
The
show mac-address-table
command does not show all of the EFPs with a given static
MAC address; the command only displays the first EFP with the MAC address.
Conditions:
Occurs when you configure the same static MAC address on multiple EFPs.
Workaround:
There is no workaround; however, the issue is cosmetic and functionality is not
affected.
•
CSCua22323
Symptom:
Bit error rate testing (BERT) does not go in sync state.
Conditions:
Occurs when you configure BERT on the PDH controller in local loopback mode.
Workaround:
Initiate BERT on both ends of the connection.
•
CSCua25779
Symptom:
An Ethernet virtual circuit (EVC) interface does not forward IPv4 traffic.