34
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Caveats in Cisco IOS XE 3.9S Releases
Workaround:
Use different timeslots, or make sure channel-group and cem-group numbers are
different under the same controller
•
CSCua57325
Symptom:
The router displays an OIR SPA error.
Conditions:
Occurs under the following conditions:
–
The router is running offloaded CFM sessions over an xconnect (pseudowire) interface.
–
The router is using a redundant hardware (dual RSP) configuration.
–
The remote router is using a non-redundant (single RSP) hardware configuration.
–
You reload the router.
–
Workaround:
There is no workaround.
•
CSCua61934
Symptoms:
When policy-map with priority in class-default is attached to interface its not getting
rejected.
Conditions:
Configure policy-map having priority in class-default. Attach the policy to interface
it’s not getting rejected.
–
Workaround:
None known at this time
•
CSCua77688
Symptom:
The router experiences remote CFM MEP flapping.
Conditions:
Occurs when the router is connected via a CFM xconnect and the link is running a high
traffic rate.
Workaround:
Reduce the rate of traffic.
•
CSCua90879
Symptom:
QoS policies with a police statement on the class-default class do not take effect.
Conditions:
Occurs when you apply a police statement to the class-default class within a QoS policy
on an ingress EVC interface.
Workaround:
Apply the police statement to a static class, such as class cos0.
•
CSCub18160
Symptom:
The router drops traffic on a link twice and displays a remote fault error message.
Conditions:
Occurs when you issue an interface module reset (OIR) while the 10.000M XFP
(DWDM Edge performance) or XFP10GER-192IR-L XFPs are plugged into the ten Gigabit
Ethernet interface module and active.
Reloading the router also takes significantly longer when using these XFPs.
Workaround:
There is no workaround.
•
CSCub26877
Symptoms:
When Bridge-domain of the efp is changed and the new bridge-domain is not accepted,
the old bridge-domain gets rejected.
Conditions:
EVC -BD configuration change.
Workaround:
None
•
CSCub33576
Symptoms:
All IMA interfaces does not come up until OIR of IM.