22
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.8S Releases
–
A QoS policy is attached to the service instance
–
The QoS policy contains a single class containing a
match efp
statement.
–
You reset the interface to the default configuration.
Workaround:
There is no workaround.
•
CSCud33906
Symptom:
Equal Cost Multipath (ECMP) loopback does not function properly.
Conditions:
Occurs when a port-channel link dynamically assigned as an ECMP path.
Workaround:
There is no workaround.
•
CSCud56262
Symptom:
The router stops passing traffic on virtual circuits.
Conditions:
Occurs an MPLS-TE/FRR configuration with L2VPN after you issue a stateful
switchover (SSO).
Workaround:
Reload the router.
•
CSCud64436
Symptom:
The router does not send the full line rate on POS interfaces.
Conditions:
Occurs when you send traffic over a POS interface on the OC-3 interface module with
a QoS configuration.
Workaround:
There is no workaround.
•
CSCud89451
Symptom:
The router crashes with an error message showing nmpls_label_populate_flow_data.
Conditions:
Occurs when you reset a core interface while the ASR 903 is acting as a PE router and
running a configuration with L2VPN and L3VPN.
Workaround:
There is no workaround.
•
CSCud95359
Symptom:
The show policy map command displays an incorrect number of total dropped packets
(total drops).
Conditions:
Occurs when you issue the show policy-map command to display dropped packets on
an interface.
Workaround:
There is no workaround.
•
CSCue01419
Symptom:
The router loses EIGRP neighborship.
Conditions:
Occurs on OC-3 and OC-12 interface configured on port 0.
Workaround:
Issue a
shutdown
/
no shutdown
on interfaces configured on port 0. You can also
remove and reconfigure EIGRP.
•
CSCue43205
Symptom:
The router drops traffic when you set an interface to the default configuration.
Conditions:
Occurs when you set an interface with QoS configurations to the default configuration.
The issue occurs most often with the Ten Gigabit Ethernet interface using a full global configuration.
Workaround:
There is no workaround.