28
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
–
The router is configured with a high number of serial interfaces
–
You reset an interface module or reload the router.
Workaround:
There is no workaround.
•
CSCuc91007
Symptom:
A slave clock displays a high 1PPS offset value from the master clock.
Conditions:
Occurs after an interface module reset or stateful switchover (SSO) on the master
device.
Workaround:
There is no workaround.
•
CSCuc95590
Symptom:
The router does not automatically upgrade the FPGA software.
Conditions:
Occurs when you load a new image while running an older FPGA version.
Workaround:
There is no workaround; however the issue has no functional impact.
•
CSCuc98185
Symptom:
One out of 48 EFPs in a BDI does not receive traffic when running L3 multicast. The
issue does not happen consistently.
Conditions:
Occurs under the following conditions:
–
You configure Protocol-Independent Multicast-Sparse Mode (PIM-SM) with a static
rendezvous point (RP).
–
You configure a bridge domain interface (BDI) on the PE2 access side
–
You use the BDI to send IGMP v2 static join messages to a single multicast group
–
You disable IGMP snooping globally.
–
You configure 24 EFPs and map them to a single bridge-domain.
–
You initiate multicast traffic.
–
With multicast traffic enabled, you configure 24 EFPs and map them to the existing
bridge-domain.
One of the 48 EFPs does not receive traffic.
Workaround:
Reload the router.
•
CSCud01644
Symptom:
The active forwarding processor (FP) is on the standby route switch processor (RSP).
Conditions:
Occurs when you boot the two RSPs in quick succession and the FP on the standby RSP
becomes active before the FP on the active RSP.
Workaround:
Reload the router.
•
CSCud07236
Symptoms:
The router displays console error messages when reloading.
Conditions:
Occurs when you reload the router.
Workaround:
There is no workaround; however, the messages have no impact on device.