Christie CP2000-X, User Manual

Page: 150 / 164

ASCII MESSAGES
B-4
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)
Function Code / Examples Description and Parameters
full cinema processing path and 1= non-cinema only.
(PRM?) What is the current processing path?
(PRM!001) Non-cinema processing path is currently in effect
Projector Address (ADR)
(ADR “192.168.206.10”)
Sets which projector—identified by its network address—
will be controlled by the TPC upon the next re-boot.
Examples might include 192.168.206.
10 or 192.168.206. 11 ,
etc. Valid IP addresses depend on the site.
(ADR?) Which projector (I.P. address) is controlled by the TPC?
(ADR!“192.168.206.10”) Projector 192.168.206.10 is controlled by the TPC.
Projector Configuration File (PCF)
(PCF “TPC1”)
Use this pre-defined projector configuration file (PCF
“filename”) for processing.
(PCF?) What pre-defined processing file is currently in effect?
(PCF! “TPC1”) The TPC1 pre-defined proj. configuration file is in use
Projector Hours of Use (PJH)
(PJH?)
How many hours have been logged on the projector?
(PJH!5672) #hours that the projector has been used (incl. standby
and without a lamp)
Maximum=16,777,215 hours
Projector Running Hours (PRH)
(PRH?)
How long has the proj. been run with the lamp on ?
(PRH!1251) Proj. has run 1251 hours with the lamp on
Save (SAV)
(SAV)
Immediately save all changes to flash rather than waiting
for eventual auto save or a power down.
Screen Format (SCF)
(SCF “filename”)
Use this screen format file (stored in projector memory).
(SCF?) What is the current screen format?
(SCF!”1920x1080”) Current screen format filename is 1920x1080
Screen Orientation (SOR)
(SOR 0)
Sets the position of the projector relative to the screen
0=Normal Front
1=Inverted Rear
2=Normal Rear
3=Inverted Front
(SOR?) What is the current screen orientation setting?
(SOR!0) Current screen orientation is normal front position
Select Input (SIN)
(SIN 0 )
Select which projector (P1) and input (P2) to use.
P1 = Projector (always 0)
P2 = Input
0=Input A (SMPTE/cinema)
1=Input B (SMPTE/cinema)
2=Dual SMPTE/cinema
3=DVI-1 (non-cinema)
4=DVI-2 (non-cinema)
Select Source Format (SRF)
(SRF “filename”)
Select the stored source file defining incoming resolution
and desired aspect ratio for the current display.
(SRF?) What is the current source format?
(SRF!”1280x1024square”) Current source format filename is 1280x1024square.
Shutter (SHU)
(SHU 0)
(SHU 1)
Open or close the electronic “quick douser”, where 0 =
open and 1 = closed
System Status (SST)
Method of reading projector information. See Messages
With Multiple Parameters later in this Appendix.