Christie CP2000-X, User Manual

Page: 55 / 164

BASIC OPERATION
CP2000-X User Manual
3-13
020-100031-01 Rev . 1 (03-2009)
Table 3.1. Summary of Status:System Menu
STATUS:SYSTEM MENU ENTRIES
Source
Projector Input Source connection (location) of current signal
Signal Vert. Freq.
Cine-IPM (not applicable for CP2000 projectors)
Power On/off
Input and Channel
Source connection (location) and channel#
Signal Hor. & Vert. Freq. of current source
Standby On/off (NOTE: lamp remains on regardless)
OSD On/off screen display of Cine-IPM menus
Environment
Projector Hours #Hours projector has been powered up and
communicating with the TPC
Total Lamp Hours #Hours logged for all lamps ever installed
Lamp #Hours logged on current lamp
Current Lamp current (#amps)
Voltage Lamp voltage (#volts)
Power Lamp power (#watts)
Footlamberts Footlamberts (interpolated from min/max calibration)
LiteLOC On/Off/At Maximum Power
Interlocks Critical safety and/or operation monitoring
Lamp Fan † (rear of projector) OK/Failure. Failure also triggers an alarm window
Extractor Fan † (for ducting to outside
world)
OK/Failure. Failure also triggers an alarm window
Lamp Door
†
(louvered lamp door) OK/Failure. Failure also triggers an alarm window
High Current OK/Failure. Failure also triggers an alarm window
Tamper
†
(projector lid) OK/Failure. Failure triggers an alarm window and
stops CineLink ® 2 -encrypted cinema processing.
Temperatures (°C or °F) * Critical internal temperatures in °C or °F
Card Cage 55-69°C=warning ≥ 70°C=critical
DMD – Blue 50-54°C=warning ≥ 55°C=critical
DMD – Red 50-54°C=warning ≥ 55°C=critical
Integrator 95-104°C=warning ≥ 105°C=critical
Prism 70-74°C=warning ≥ 75°C=critical
SSM 55-59°C=warning ≥ 60°C=critical
Fan Speeds * Speed (RPMs) of 4 internal cooling fans
Fan #1 (“Intake #1”) RPMs of 1 st primary fan (exhaust side of proj.)
Fan #2 (“Intake #2”) RPMs of 2 nd primary fan (exhaust side of proj.)
Card cage RPMs of electronics card cage fan
LAD RPMs of laminar airflow device for DMDs
Built-in Self-Test
NOTE: If any of the following indicators are “red”, service may be needed.
General
System
Power-up Self Test
Security Lock Integrity
I 2 C
Interface Board
Diagnostics Performed
ARM
FPGA Load
FPGA Code Valid
FPGA Initialize
FPGA No-Load Jumper
FPGA Done
FPGA Register Read/Write
UART 0
UART 1
I
2
C
Ethernet
Synchronous Serial Port
File System
GPI Macro
A/D Macro
Formatter Board (a.k.a. Formatter Interface
Board)