Christie CP2000-X, User Manual

Page: 119 / 164

MAINTENANCE
CP2000-X User Manual
6-7
020-100031-01 Rev . 1 (03-2009)
The high brightness of your projector is provided by a Xenon lamp mounted at the
ends within a reflector, housed in the locked lamp compartment of the projection
head. When the lamp approaches the end of its life, it must be replaced—do not
exceed warranted lamp life by more than 20%, as an old lamp becomes increasingly
and dangerously fragile, resulting in possible explosion.
To determine the age of your current lamp, consult the Status menu in the Touch
Panel Controller . Lamp hours appear under “Environment: Lamp”. Lamp hours are
also displayed in the password-protected Advanced Lamp menu and the Advanced
Lamp History menu.
It is recommended that you replace the air filter with every lamp replacement, or
sooner in dusty or dirty environments. Check its condition monthly in all projectors.
NOTE:
For this procedure you will need a compatible Christie Xenon CDXL or CXL
lamp as shown in Section 8, Specifications— never install a lamp intended for a
different model or projector.
WARNING
Make sure to use the correct wattage lamp supplied by Christie.
WARNING
Lamp replacement is to be done by
a qualified service technician only.
WARNING
EXPLOSION HAZARD —Wear authorized protective
clothing whenever the lamp door is open! Never apply a
twisting or bending force to the quartz lamp body.
Read and follow all other general lamp precautions in 6.1, Warnings and Guidelines .
Turn off the projector
Allow the fans to run at least 10 minutes for cooling.
WARNING
Never attempt to remove the lamp when it is hot. The
lamp is under great pressure when hot and may
explode, causing personal injury and/or property
damage.
Allow to cool completely.
Set the ballast breaker (power switch) to
OFF.
Disconnect projection head and ballast from AC supply
WARNING
SHOCK HAZARD. Disconnect both components from AC.
Open the lamp door
With protective clothing and shield on , unlock the lamp door and open it. Refer back
to Figure 2.20. If desired, release the latch mechanism to remove the door entirely.
6.4 Replacing the
Lamp & Filter
Lamp Replacement

Procedure
STEP 1

STEP 2 
STEP 3

STEP 4
