ASCII MESSAGES
CP2000-X User Manual
B-9
020-100031-01 Rev. 1 (03-3009)
Table B.6. System Status Messages
P1
P2
Notes
If P1 = 0
General
Projector
Configuration
0 = Model
1 = Serial Number
2 = Build date
3 = Native Resolution
4 = Factory Settings
5 = Max Lamp Power
If P1 = 1
System Status
0 = Power Status (0=Off, 1=On)
2 = LiteLOC (0=Off, 1=On, 2=power for
LiteLOC is at its maximum)
3 = Lamp Expiry
4 = Lamp Hours
5 = Total Lamp Hours
6 = Rental Hours
7 = Projector Hours
8 = Shutter (0=Off, 1=On)
20 = Lamp Current
21 = Lamp Voltage
22 = Lamp Power
23 = Approximate foot lamberts
If P1 = 2
Signal
Information
0 = Signal status (0=OK, 2=invalid)
1 = Channel#
2 = Vertical frequency
3 = Test Pattern (0=Off, >0=On)
Good or bad signal
Current channel (101-108)
Current vertical frequency
If P1 = 3
Operation
Status
2 = Lamp Error
10 = Card cage temperature
11= Blue DMD temperature
12 = Red DMD temperature
13 = Integrator temperature
14 = Prism temperature
15 = SSM temperature
20 = Lamp vane switch interlock
21 = Extractor vane switch interlock
22 = Lamp door interlock
23 = Auxiliary interlock
30 = “Intake” fan #1 (rear) speed
31 = “Intake” fan #2 (front) speed
32 = Card cage fan speed
33 = LAD fan speed
0=OK, 1=Unexpected lamp
shutdown, 2=Ignition failure
°C. Shows caution or critical
°C. Shows caution or critical
°C. Shows caution or critical
°C. Shows caution or critical
°C. Shows caution or critical
°C. Shows caution or critical
(0=OK, 1=open)
(0=OK, 1=open)
(0=OK, 1=open)
(0=OK, 1=open)
RPM. Also indicates “slow”
or “failed” condition.
“
“
If P1 = 4
Versions
0 = Touch Panel (Main)
1 = Touch Panel (Language)
2 = Touch Panel (Operating System)
3 = System Supervisor Module (Main)
4 = System Supervisor Module (Boot)
5 = System Supervisor Module (h/w)
6 = Ballast Interface (h/w)
7 = Stepper Driver (Main)
8 = Stepper Driver (h/w)
20 = Engine
21 = Interface (ARM Boot)
22 = Interface (ARM Main)
23 = Interface (FPGA)
24 = Interface (PIC)
25 = Processor (DSP Boot)
26 = Processor (DSP Main)
27 = Processor (DSP Diag.)
28 = Processor (DSP FPGA)
Indicates version detected in
projector.
Summary of Contents for CP2000-X
