INSTALLATION AND SETUP
CP2000-X User Manual
2-21
020-100031-01 Rev . 1 (03-2009)
ADD EXTRACTOR:
See Figure 2.25.
Connect the other end of the duct to the
Christie heat extractor/blower, twisting to
secure “flaps” over pins on the fan. Make
sure that the
grille
end of the fan faces
down
. For longer exhaust runs at your
site, add extractors/boosters as
necessary—the vane switch at the
projector’s top exit port will trigger a
projector shutdown if the airflow is
inadequate. To prevent possible transfer
of fan vibration to the image, do not
mount the extractor directly on the
projector—include at least 6” of duct.
WARNING
Do not exceed 6-ft. duct length without
adding additional extractors.
To suspend the projector/fan assembly,
always use appropriate rigging hardware
and secure to adequate support structures
at your site.
The Christie 6-ft. duct-with-fan
weighs approximately
22 lb
.
The Christie 6-in. duct-with-fan weighs approximately
15 lb
.
Use third-party extractors only if the minimum of 600 CFM airflow can be
maintained.
SECURE SAFETY CABLES:
Three safety cables are provided, and are all mandatory
whenever the fan/duct assembly is suspended. These cables prevent components from
falling if your rigging equipment fails. Figure 2.26 shows the safety cable required
between the cooling assembly and projector in any installation, flown or not. Attach
remaining safety cables between the 1) duct and fan, and 2) fan and supporting
structure.
Figure 2.25. Securing Extractor to
Duct
Summary of Contents for CP2000-X
