Christie CP2000-X, User Manual

Page: 107 / 164

CINEMA OPERATION
CP2000-X User Manual
4-5
020-100031-01 Rev . 1 (03-2009)
NOTE: For details regarding all TPC functions, refer to 3.5, Using the Touch Panel
Controller.
As described in 3.5, Using the Touch Panel Controller , cinema displays are usually
pre-configured so that any user can correctly display a desired feature simply by
selecting the corresponding button on the Main menu of the
Touch Panel Controller .
There are a maximum of 32 display buttons available at any one time (8 per page),
with most users locked out of other processing controls available in other
Touch
Panel Controller menus. For cinema sources in particular, which are displayed
according to strict parameters pre-defined by the producers of the feature and
implemented in the projector by a
CP2000-X installer, administrator or trained
operator, this simplicity ensures that the intended display can be selected quickly and
easily by any user (Figure 4-7).
To change to a new feature, do the following:

Make sure the CP2000-X and TPC are both powered up and operating normally.

On the Touch Panel Controller , select the Main menu tab.

On page 1 or 2 of the Main menu, press the desired channel button—the image
will update according to the display configuration defined for it.
Refer back to 3.5, Using the Touch Panel Controller for other operating details.
Figure 4.7. Select the Desired Cinema Source
NOTES:
1)
Depending on your expected needs, your installer may or may not have
configured all 32 buttons for use.
2)
Buttons may have any icon or text.
Depending on your installation, you may be able to select a source from a different
controller in a remote location by sending ASCII commands via an Ethernet
communication link. See
3.6, Remote Control of the Touch Panel Controller , and
Appendix B, ASCII Messages .
4.3 Selecting the
Cinema Source
Via Touch Panel Controller

Other Methods 
Controller
Tou
ch Panel