BASIC OPERATION
CP2000-X User Manual
3-21
020-100031-01 Rev . 1 (03-2009)
Using the Custom 3D Control Menu
NOTES:
1)
3D functionality requires an EFIB (Enhanced Formatter Interface Board
as well as a Series 1 Interface board. Consult the
About
menu.
2)
Connect your 3D
HD-SDI source signals to cinema A and B ports (dual).
3)
Assumes software v8.0 or
higher.
Custom 3D Control
menu options are summarized in Figure 3.10 and Table 3.5.
Enable the 3D checkbox in order to 1) enable 3D display and adjustment parameters
2) automatically configure the
Input
and
Data Format
(on the
Custom Page-1
menu).
For full 3D application notes, including a step-by-step tutorial for use, see section
3.9, Working with 3D
.
Figure 3.10. Custom:3D Control Menu
Table 3.5. Summary of Custom 3D Control Menu Functions
CUSTOM: 3D CONTROL MENU OPTIONS (SUMMARY)
Enable 3D (checkbox) Activate 3D controls and auto-set
Input
to
292 Dual Input
and
Data
Format
to
Unpacked 4:2:2
in the
Custom Page-1
Enable 3D Test Pattern For confirming proper
Sync Output
setting (i.e., which GPO is connected to
your 3D peripherals such as emitters, glasses, etc.
3D Input Reference Defines how 3D stereo sync input is supplied (currently ports A and B
only).
See “NOTES” below.
Input Frame Reference Define frame order (L-R or R-L) required for 3D perspective. Correct
setting ensures smooth motions, and depends on the original source
mastering.
See “NOTES” below.
L/R Output Polarity Keeps 3D stereo sync output the same as input (true), or reversed
(inverted).
See “NOTES” below.
Frame Rate N:M Ratio of total #frames displayed to #frames forming complete data.
Increase to reduce flicker in displays < 96 Hz. Max. recommended
setting for 2048 x 1080 displays = 5:2. Can be higher in smaller
displays, or decreased if incoming signal is already high enough to
prevent flicker.
See “NOTES” below.
Input GPI Select “None” when 3D stereo sync input is part of source signal at
ports A and B. Use GPI 1-7 if sync input is supplied to GPIO port. (Must
match L/R Input Reference setting.)
Display GPI Always “None” unless 3D stereo sync input is at GPIO connector. (Must
match L/R Display Reference setting.)
Output GPO Define your GPO sync output for 3D device (glasses or z-screen
polarization), using to 1-7 depending on wiring.
Dark Time Adj Create a blank time interval between L/R frames to allow for glasses
on/off. Helps synchronize the output to the viewing.
Output Delay (Time) Offset (in
μ
) 3D stereo sync output in relation to dark time interval.
Positive offset = delay, negative offset = start early.
See “NOTES”
below.
Summary of Contents for CP2000-X
