SYSTEM INTEGRATION
C-2
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)
Figure C.1. GPIO Connector Pinouts
As shown above, each available pairing of pins (+/–) is defined as either an
input
or
output
. Configure a pin as an input if you want the projector to respond to an
incoming signal, or as an output if you want an external device to respond to the
projector. For example, configure the pin as an output in order to drive an external IR
emitter for 3D glasses, or to automatically reduce room lighting when the projector is
turned on.
Figure C.2. Circuit for Power Supply
If you are wiring your own GPIO cable for use with a server or 3D device such as an
IR emitter or a polarizer, follow the circuit diagram in Figure C.2.
Example: GPIO and 3D Device
1.
Assemble a cable according to guidelines shown in Figure C.1and Figure C.2.
2.
Connect the cable to projector’s GPIO port and to your 3D device.
3.
In the TPC’s
Custom 3D Control
menu, set
Output GPO
according to the pins
wired in the GPIO cable (see Figure C.1). For instance, if you have wired pins
#10 (+) and #29 (–) to your 3D device, set
Output GPO
to GPO #2.
Summary of Contents for CP2000-X
