Christie CP2000-X, User Manual

Page: 152 / 164

ASCII MESSAGES
B-6
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)
Table B.2. Error Messages
Error Code (P1) Type of Error (P2) Meaning
001 “System Error: -----” System critical error.
002 “System Warning: -----” System error.
003 “Invalid parameter—“ Invalid parameter number.
004 “Too many parameters” Message requires fewer parameters
005 “Too few parameters” Message requires more parameters
006 “Source does not exist” The source# is wrong
007 “Could not be
executed”
Current content prevented the command
from executing.
008 “Checksum error” The checksum is incorrect.
009 “Unknown request” Message code undefined. If the message
sent as a command it is ignored and no
error is returned.
010 “Communication error” Error receiving serial data on one of the RS-
232 ports.
Additional Parameters for “001” System Errors and “002”System
Warnings
“System Error” and “System Warning” error messages include two additional
parameters (P3 and P4), which further describe the error. P3 indicates what
component or system is involved (such as interlocks, fans, temperature, SSM
communication, or a lamp failure) and P4 relays the specific condition detected at the
suspect component, such an over-temperature reading or a slow fan speed reading—
note these values indicate temperature or fan speed only. See Table B3, B4, and B.5
below.
When a system error is resolved and is no longer present, another message reports
this by replacing the first digit in the original P3 error code with a “1”.
Table B.3. P3 Codes for “001” System Error Messages”
Component Code (P3) Component
0001 Interlock, Lamp Fan
0002 Interlock, Extractor
(exit duct to outside world)
0003 Interlock, Lamp Door
0004 Interlock, Auxiliary
0005 Interlock, Tamper
0008 Fan, Intake 1
(non-operator’s side of projection head)
0009 Fan, Intake 2
(non-operator’s side of projection head)
000A Fan, Card Cage
000B Fan, LAD
(laminar airflow device near light engine)
000C Fan, Ballast
0010 Temperature, Prism
0011 Temperature, DMD Red
0012 Temperature, DMD Blue
0013 Temperature, Integrator
0014 Temperature, SSM
(System Supervisor Module)
0015 Temperature, Card Cage
0016 Temperature, Ballast
0021 Lamp, Failed to Ignite
0022 Lamp, Ignition Failed on 2 nd Strike
0023 Lamp Off (detected by no light or current)
0024 Light Sensor Reading Failure
0030 SSM, Communication Failure
(System Supervisor Module)