Section 2
Installation & Setup
CP2000-X User Manual
2-1
020-100031-01 Rev . 1 (03-2009)
This section explains how to install, connect, and optimize the projector.
NOTE:
Unless otherwise specified, illustrations apply for either CP model and may
not always show the rear-mounted TPC.
Follow these steps for quick setup of the projector in a basic front mount position.
Position the Projection Head
Locate the projection head at an appropriate throw distance (projector-to-screen
distance) and vertical position. See
2.3,
Projector Position and Mounting
. Make sure
that the projector is level from side-to-side, and
do not invert
. Locate the lamp ballast
so that its 4 cables can reach the rear of the projection head.
Install the Touch Panel Controller
(TPC)
Attach the
Touch Panel Controller
,
pre-assembled with its ball joint base
and mounting arm, to the matching ball
joint base secured at the rear of the
projector. Plug the TPC into the TPC
port on the projector’s rear connector
panel using the standard 3-ft. cable
provided.
Alternatively, mount the TPC in a
remote location up to 50 feet away and
attach to the rear of the projector using the optional long-distance cable.
Install Lens, Lamp and Heat Extractor
Refer to
2.4, Installing a Lens, Lamp & Cooling
for instructions.
2.1 Quick
Setup
STEP 1
STEP 2
Figure 2.1. Installing the TPC
STEP 3
STEP 4
Summary of Contents for CP2000-X
