Christie CP2000-X, User Manual

Page: 23 / 164

INSTALLATION AND SETUP
CP2000-X User Manual
2-15
020-100031-01 Rev . 1 (03-2009)
Figure 2.19. Side-to-Side Tilt
Special Orientations
Since this projector cannot be inverted or tilted beyond 15

during use, all
installations are front-mount and require the “Normal Front” Image Orientation
setting in the
Admin: General menu. For shipping, remove lamp and rotate the
projector box as needed.
For some installations such as large venue rental/staging applications, you will likely
have to safely lift or hoist this projector—or a stack of 2 projectors—into place. Keep
in mind the following
critical safety guidelines for all handling of the projector.
Carrying/Moving the Projection Head
Four or more people can lift and hand-carry one projection head (with or without a
FredFrame  ) a short distance as required. Never attempt to carry a stack by hand. To
use equipment such as a forklift to move the projection head, always install a
FredFrame
 first.
Using a Forklift
WARNING
Do not attempt to use a forklift without first installing the
fork lift rails on the bottom of the FredFrame

,
otherwise the base of the projector may crush and
damage internal components.
Strong extruded rails that mount to the bottom of the FredFrame

accommodate
forks from a forklift, and are mandatory for this method of transport. Do not lift the
projection head with equipment unless the FredFrame
 and forklift rails are
installed. Always follow the instructions provided with the FredFrame  kit.
Using the FredFrame

To hoist, stack and/or “fly” projectors, you must properly secure each projection head
within a FredFrame
 and use appropriate rigging and safety cables to raise and/or
suspend this assembly. If desired, the lamp ballast can also be hoisted and flown from
its integral rigging bars. Follow the instructions provided with the FredFrame

kit.
Hoisting and Stacking 