Canon iR5055, Service Manual

Page: 255 / 646

Chapter 8
8-33
F-8-63
5) Remove the cassette 4 lifter motor M21 [3].
- 2 fixing screws [1]
- 1 connector [2] (Free the connector cable from the wire saddle)
F-8-64
8.11.4.3 Adjusting the Position of the Lifter Motor M20/
M21 of the Cassette 3/4
0016-0031
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Remove the cable from the wire saddle, and detach the guide plate [3].
- 1 connector [1]
- 3 screws [2]
F-8-65
2) While keeping the lifter motor M21/M21 [1] to the right side, tighten the
screw [2] temporally.
F-8-66
3) Set the cassette 3/4 in the machine without paper.
4) Check to make sure the lifer drive guar [1] is engaged with the lifter motor
guar [2] from the right side of the machine.
5) Check to make sure the lifter drive guar is fully away from the lifter motor
guar when the release button of the cassette 3/4 [3] is pressed halfway.
The condition of “pressing released button halfway” is following.
- Separation roller should move down.
- The cassette roller is about to slide out.
F-8-67
6) If the lifter drive guar is not away from the lifter motor, move the position
of the lifter motor M20/M21 [1] to the left and check again with keeping
the release button of the cassette 3/4 pressed halfway.
F-8-68
7) Fully tighten the 2 screws of the lifter motor M20/M21.
8) Mount back the removed parts and turn the machine on.
9) Check to make sure the cassette can be fully slid out when the cassette re-
lease button is pressed under the following conditions.
- The cassette contains no paper
- The cassette contains about 550 paper
8.11.5 Left Deck Lifter Motor
8.11.5.1 Before Removing the Left Deck Lifter Motor
0015-4980
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Remove the charger unit (this step is necessary only for iR5075 for Japan).
(page 10-22)
Reference[Removing the Charger unit]
2) Remove the rear cover (upper).
(page 10-13)
Reference[Removing the
Rear Cover (Upper)]
3) Detach the rear cover (lower).
(page 10-13)
Reference[Removing the
Rear Cover (Lower)]
4) Remove the HVT PCB.
(page 10-28)
Reference[Removing HVT PCB]
8.11.5.2 Removing the Left Deck Lifter Motor
0015-4982
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Open the 2 wire saddles [1] and free the 2 harnesses [2].
2) Remove the left deck lifter drive assembly [5].
- 3 screws [3]
- 2 connectors [4]
[1]
[2]
[1]
[1]
[1]
[2]
[3]
[1]
[3]
[1]
[2]
[2]
[1]
[2]
[1]
[2]
[2]
[1]