Canon iR5055, Service Manual

Page: 86 / 646

Chapter 2
2-24
10) Cut the area [1] of the right cover (upper) with a wire cutter etc.
F-2-94
11) Attach the right cover (upper) detached in the step 2).
12) Close the toner replacement cover.
13) Insert the power cable (for the plug).
14) Turn on the main power switch, and then check the display demanding
setting of the control card.
15) Input the card number (1 to 2001) to be used in the service mode (COP-
IER > FUNCTION > INSTALL > CARD).
- Input the smallest card number for the user to use.
- Up to 1,000 cards having been input are available.
16) Operate the touch panel following the instruction on the screen of shut-
down sequence in order to turn off the main power switch.
17) Turn on the main power switch.
18) Insert the control card and check the status where copy is possible.
2.7.5 Installing for imageWARE Accounting Manager
0015-7624
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Check to see that 'ID00000001 to ID00001000' has been created in >
[System Settings] > [Dep ID Mangement] > [Registor Dept.ID/Password]
> [Page Totals]. (In the case that '1' has been input as the first number by
the service mode; COPIER > FUNCTION > INSTALL > CARD)
2) Press the reset key to escape the user mode screen.
3) Select > [System Settings] > [Network Settings] > [TCP/IP Settings]
> [IP Address Settings], and then make the setting of [IP Address], [Gate-
way Address], [Subnet Mask] according to the user environment
4) Press the reset key to escape the user mode screen.
5) Operate the touch panel following the instruction on the screen of shut-
down sequence in order to turn off the main power switch.
6) Turn on the main power switch.
7)
> [System Settings] > [System Maneger Settings], and then input
any number into [System Maneger ID] and [System Password].
8) Press the reset key to escape the user mode screen.
9) Turn off the power according to the shutdown sequence.
2.8 Installing the Original Holder
2.8.1 Checking Contents
0015-4777
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
<Document Tray-K1>
F-2-95
2.8.2 Installation Procedure
0015-4778
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Tighten the 2 stepped screws (M4X33) [1] to the upper cover (right).
F-2-96
2) Hook the document tray [1] to the stepped screws tightened in the step 1.
F-2-97
> [System Settings] > [System Maneger Settings] is selected and
[System Maneger ID] and [System Password] are registered, 'Registration
of card to the device' is impossible to execute in the setting of iWAM.
[1]
[1]
Document Tray 1 pc.
[2]*
Stepped Screw (M4X31) 2 pc.
[3]
Stepped Screw (M4X33) 2 pc.
* Not used with this host machine.
[1]
[2] [3]
[1]