Canon iR5055, Service Manual

Page: 504 / 646

Chapter 16
16-4
E013 The waste toner pipe is clogged.
0000 The waste toner pipe is identified as being clogged for 4 sec or more. - Check the connector for any fault in connection.
- Replace the waste toner feedscrew lock detecting switch.
- Replace the waste toner feed unit.
- Replace the DC controller PCB.
0010 The power has been turned off and then back on without resetting the error.
E014 There is a fixing motor error.
0000 The Phase lock signal of the fixing motor does not arrive for 2 sec even
when the fixing motor has been turned on.
- Check the connector for any fault in connection.
- Replace the motor.
E020 There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection
of hopper toner sensor connection
0000 The presence of toner is detected inside the sub hopper and, in addition, the
absence of toner is detected inside developing assembly for 120 sec
continuously even when operation has been under way for the supply of
toner to the developing assembly.
- Check the connector of the developing toner sensor for any fault in
connection.
- Replace the developing toner sensor.
- Replace the hopper toner sensor.
0001 At power-on, the connection of the developing assembly toner sensor is not
detected.
- Check the connector for any fault in connection.
- Replace the sensor.
0002 At power-on, the connection of the developing hopper toner sensor is not
detected.
- Check the connector for any fault in connection.
- Replace the sensor.
E025 There is a toner feed motor over-current detection error, there is a toner bottle motor connection detection error.
0001 An over-current has been detected in the toner feed motor. - Check the connector for any fault in connection.
- Replace the motor.
0002 An over-current has been detected in the toner bottle motor. - Check the connector for any fault in connection.
- Replace the motor.
0003 At power-on, the connection of the toner bottle motor is not detected. - Check the connector for any fault in connection.
- Replace the motor.
E032 The NE controller counter has malfunctioned.
0001 An open circuit has been detected for the count pulse signal. Turn off the main power, and check for an open circuit in the cable; then,
turn the main power back on.
E061 There is a potential control error/there is an APC error.
0001 As a result of potential control, the drum surface potential (VL2) of the
background is 200 V or higher (i.e., causing a solid black image).
- Replace the potential sensor unit.
- Replace the laser scanner unit.
- Replace the DC controller PCB.
0002 The primary charging output used at time of printer output and the drum
surface potential after laser output is identified as being 200 V or more (i.e.,
causing a solid black image).
E100 There is a BD error.
0001 A check is made of VLOCK at intervals of 100 msec while the laser is on.
An error will be identified if it is not detected 10 times in sequence.
- Replace the laser scanner unit.
- Replace the DC controller PCB.
E102 There is a laser verify error.
0001 The machine model ID that has been read from the laser scanner EEPROM
is not correct.
E110 There is a polygon motor error.
Code Description Remedy