Canon iR5055, Service Manual

Page: 72 / 646

Chapter 2
2-10
F-2-29
2) Remove the tape [1], and detach the hopper supply mouth cover [2].
F-2-30
3) Take out the developing assembly from the packing box.
4) Rotate the developing cylinder gear [1] with hand and check if there are
any cuts on the cylinder [2].
F-2-31
5) Hold the center (grip of the assembly) of the developing assembly [1] and
install it.
Then, connect the connector [2].
Then, connect the connector [2].
F-2-32
6) Fit the developing assembly pressure unit [1] to [2], and slide it in hori-
zontally in the [A] direction; then, shift toward the [B] direction.
- 1 screw (binding; M4X6) [3]
F-2-33
2.2.7 Installation of Pickup Assembly
0015-4662
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Remove the pickup roller pressure release spacer [1].
When mounting the developing assembly, be sure not to contact the
developing cylinder with the developing assembly mounting plate.
[1] [2]
[2]
[1]
[2]
[1]
Remove the pickup roller pressure release spacer [1] while moving the front
side of it upward after sliding the spacer toward the right.
[1]
[2]
[1] [3]
[A]
[B]
[2]
[1]