Canon iR5055, Service Manual

Page: 308 / 646

Chapter 9
9-28
F-9-69
2) Remove the silicone oil tray [2].
- 1 screw [1]
F-9-70
3) Detach the harness retaining cover [2].
- 1 screw [1]
F-9-71
4) Free the harness from the harness guide assembly [1].
F-9-72
5) Shift the thermistor mounting shaft [2] to detach it from the bushing.
- 2 screws [1]
- 1 reuse band [3]
F-9-73
6) Remove the 2 leaf springs each [1] to remove the main thermistor [2] and
the shutter thermistor [3].
F-9-74
9.5.7.3 Points to Note When Mounting the Main
Thermistor/Shutter Thermistor
0015-5056
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
- Route the harness of the thermistor as shown below. The harness [1]
should route via the outside (the rear side) of the guide pin [2].
F-9-75
- After mounting, make sure the main thermistor [1] and the shutter
thermistor [2] are parallel and contact with the fixing roller. If not, restart
the mounting steps
F-9-76
9.5.8 Sub Thermistor
9.5.8.1 Before Removing the Sub Thermistor
0015-7192
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Detach the duplexing feed front cover.
(page 10-14)
Reference[Remov-
ing the Duplexing Feed Front Cover]
2) Slide out the fixing/feeding unit.
(page 9-19)
Reference[Removing the
Fixing/Feeding unit]
3) Detach the fixing front cover.
(page 10-16)
Reference[Removing the
Fixing Front Cover]
4) Detach the fixing/feeding unit front cover.
(page 10-15)
Reference[Re-
[1]
[2]
[3]
[1] [2]
[1] [2]
[1]
[1]
[2] [3]
[1] [1] [2] [1] [1] [3]
[1] [2]
[1] [2]