Canon imageRUNNER ADVANCE C5500 Series, Service Manual, Page: 958 / 1331

COPIER > OPTION > IMG-SPD
FIX-ROT 1 Set idle rtn stop cndtn after s-ppr feed
Detail Temperature on the edges of the Fixing Film becomes higher than the temperature at the center
when feeding large size paper after small size paper through the Fixing Assembly. Idle rotation is
executed until temperature is decreased to the specified value after feeding small size paper to
prevent occurrence of fixing offset or wrinkles.
To set the temperature and time as the conditions to stop idle rotation.
Temperature: Offset value from the specified temperature (deg C)
Time: Tolerance (seconds) When the time exceeds the tolerance, idle rotation is stopped even if
the temperature is not decreased to the desired temperature.
Increase the value when fixing offset or wrinkles occur. Because temperature is decreased, image
quality is improved, but productivity is decreased.
When the value is decreased, temperature is increased. As a result, productivity is increased, but
image quality may be decreased.
Use Case - When fixing offset occurs on the edge of paper
- Upon user's request (to improve productivity)
Adj/Set/Operate Method 1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range -2 to 2
-2: +20 deg C, 10 seconds
-1: +10 deg C, 20 seconds
0: 0 deg C
1: -10 deg C, 45 seconds
2: -20 deg C, 60 seconds
Unit deg C
Default Value 0
Amount of Change per
Unit
5
INTPPR-2 2 Set multi tone ctrl (light) stop intvl
Detail To set the number of sheets which the real-time multiple tone control (light) and automatic
adjustments (discharge current control and primary transfer ATVC control) at paper interval are
not executed, from the start of a job.
If interruption occurs immediately after starting a job, process speed cannot be maintained. Disable
each control not to interrupt an ongoing job until a specified number of sheets are fed to prevent
decrease in productivity.
Increase the value when prioritizing productivity over image quality, and decrease the value when
the density varies dramatically.
Use Case - When the density varies dramatically
- Upon user's request (to improve productivity)
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Caution Do not set a value larger than those of INTPPR-1 and INTROT-1.
Display/Adj/Set Range 5 to 1000
Unit sheet
Default Value 60
Related Service Mode COPIER> OPTION> IMG-DEV> INTPPR-1
COPIER> OPTION> FNC-SW> INTROT-1
Amount of Change per
Unit
1
8. Service Mode
944