Canon imageRUNNER ADVANCE C5500 Series, Service Manual, Page: 953 / 1331

COPIER > OPTION > NETWORK
LINKWAKE 2 Set of deep sleep recovery at link-up
Detail To set whether to recover from deep sleep when link-up (disconnection and then connection of
LAN cable) is detected.
Set 0 if the closest hub or switch chatters at link-up. It can prevent recovery from deep sleep
triggered by chattering.
Use Case When the machine recovers from deep sleep due to chattering of the closest hub or switch
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Not recovered, 1: Recovered
Default Value 1
WIFIRFCH 2 For R&D
Amount of Change per
Unit
1
BLEPOWER 2 Set of Bluetooth radio field strength
Detail To set the radio field strength for transmission over BLE (Bluetooth Low Energy).
As the value is changed by 1, the radio field strength is changed by 1 dBm.
Use Case When radio field strength of BLE is not appropriate
Adj/Set/Operate Method 1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Caution Do not change the setting in Singapore. It is prohibited by law.
Display/Adj/Set Range -10 to -1 (-10 to -1 dBm)
Default Value -5
■ ENV-SET
COPIER > OPTION > ENV-SET
ENVP-INT 1 Temp&hmdy/Fix Film temp log get cycle
Detail To set the cycle to obtain log of the temperature and humidity inside the machine and the surface
temperature of the Fixing Film.
As the value is incremented by 1, the cycle is increased by 1 minute.
Collected log can be displayed in COPIER> DISPLAY> ENVRNT.
Use Case At problem analysis
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 480
Unit min
Default Value 60
Related Service Mode
COPIER> DISPLAY> ENVRNT
Amount of Change per
Unit
1
DRY-CISU 1 ON/OFF of condensation prevention mode
Detail To set ON/OFF of condensation prevention mode.
Set 1 when an image failure or E225 occurs due to condensation in the Scanner Unit. From the
next startup, the Scanner Unit (for front side) stops the fan for 15 sec and the Scanner Unit (for
back side) lights LED for 30 sec.
Use Case When droplets appear on the Scanner Unit due to condensation and image failure or E225 occurs
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: OFF (Normal mode), 1: ON (Condensation prevention mode)
Default Value 0
8. Service Mode
939