Canon imageRUNNER ADVANCE C5500 Series, Service Manual, Page: 894 / 1331

■ CST
COPIER > FUNCTION > CST
DK1-SPAD 1 Set Paper Deck Unit lifter stop position
Detail To open the compartment of the Paper Deck Unit while the lifter stops at the pickup position.
The height of the Pre-separation Plate can be adjusted because the lifter is at the pickup position.
Use Case When adjusting pre-separation position after replacing the Pickup Unit/compartment
Adj/Set/Operate Method Select the item, and then press OK key.
■ CLEANING
COPIER > FUNCTION > CLEANING
2TR-CLN 1 Clean of Secondary Transfer Outer Roller
Detail To clean soiling adhered on the Secondary Transfer Outer Roller.
Transfer toner to the Secondary Transfer Outer Roller once and then execute bias cleaning to
remove soiling.
Use Case - When the backside of the paper is soiled by the Secondary Transfer Outer Roller
- When contacting with the Secondary Transfer Outer Roller at the time of jam processing, etc.
Adj/Set/Operate Method Select the item, and then press OK key.
Display/Adj/Set Range
During operation: ACTIVE, When operation finished normally: OK!
TNR-COAT 1 Exe toner application to Sec Trns Roller
Detail When the Secondary Transfer Outer Roller is replaced with a new one, substances leaking from
the new roller may adhere to the ITB.
By executing this item after replacement, Y-color toner is applied onto the surface of the roller, so
adhesion of substances leaking from the roller can be prevented.
Use Case When replacing the Secondary Transfer Outer Roller
Adj/Set/Operate Method Select the item, and then press OK key.
Caution Be sure to execute this item to the roller which surface is not soiled.
Display/Adj/Set Range During operation: ACTIVE, When operation finished normally: OK!
■ FIXING
COPIER > FUNCTION > FIXING
NIP-CHK 1 Checking of fixing nip width
Detail To check whether the fixing nip width is appropriate by printing.
When this item is executed, 2-sided print is started. A single Bk-color solid image is printed on the
1st side. Nothing is printed on the 2nd side but the paper is stopped briefly at the fixing nip.
There will be fixing nip trace at the center of the image on the 1st side of the delivered paper. Fixing
nip with at 5 mm from each edge of paper and at the center of the paper is within 8 to 10 mm, it
can be judged as appropriate.
Otherwise, a fixing failure may occur.
Use Case - When replacing the fixing-related parts (Fixing Film Unit, Pressure Roller)
- When a fixing failure occurs
Adj/Set/Operate Method 1) Set A4/LTR plain paper 2 (76 to 90 g/m2) on the Multi-purpose Tray.
2) Select "MPT", and then press OK key.
Two-sided printing is started, and a paper is automatically stopped at the fixing nip (10 seconds)
and then is automatically delivered.
3) Measure the nip width.
Display/Adj/Set Range During operation: ACTIVE, When operation finished normally: OK!
8. Service Mode
880