Canon imageRUNNER ADVANCE C5500 Series, Service Manual, Page: 1000 / 1331

COPIER > OPTION > USER
DPT-ID-7 2 Password entry set at dept ID reg/auth
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to require a password entry at the time of registration/authentication of department
ID.
With the setting to require entry, entry of 7-digit password is required as well as entry of department
ID.
Use Case Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Department ID only, 1: 7-digit (password) entry
Default Value 0
RUI-RJT 2 Connct set at invalid auth from remoteUI
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set to disconnect HTTP port when the machine receives invalid authentication from remote UI
3 times.
Use Case
Upon user's request
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0 to 1
0: Continued connection, 1: Disconnected
Default Value
0
SND-RATE 2 Set compress ratio at SEND high compress
Detail To set the compression ratio when the data compression ratio for SEND (transmission) is set to
"High Rati".
As the value is larger, the compression ratio is higher (the file size becomes small).
Use Case When making the transmission file size smaller
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution As the value is larger, image quality is decreased.
Display/Adj/Set Range 0 to 2
0: Compression ratio 1/16, 1: Compression ratio 1/20, 2: Compression ratio 1/24
Default Value 0
Additional Functions
Mode
Function Settings> Send> Common Settings> Data Compression Ratio
FREG-SW 2 For R&D
IFAX-SZL 2 Setting of IFAX send size limit
Detail To set for restricting data size at the time of IFAX transmission that does not go through the server.
With the setting to restrict the data size, there will be #830 error in the case of sending data that
exceeds the upper limit value.
In the case that the data goes through the server, the size of transmission data is always restricted.
Use Case Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Limited, 1: Not limited (Restriction applies when data goes through the server.)
Default Value 1
Additional Functions
Mode
Function Settings> Send> E-Mail/I-Fax Settings> Maximum Data Size for Sending
Supplement/Memo Set the upper limit value for transmission data size in Settings/Registration menu.
8. Service Mode
986