Canon imageRUNNER ADVANCE C5500 Series, Service Manual, Page: 957 / 1331

COPIER > OPTION > FEED-SW
EVLP-FS 2 Setting of fixing speed: envelope
Detail To set fixing speed when feeding envelope.
As the value is changed by 1, the fixing speed is changed by 0.1%.
Decrease the value when fine line displacement occurs on trailing edge of envelope, and increase
the value when wrinkles occur.
Use Case When fine line displacement or wrinkles occur on trailing edge while feeding envelope
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution Be sure to change the value a little at a time. Otherwise, fine line displacement/wrinkles occur
when setting an extreme value.
Display/Adj/Set Range -20 to 20
Unit %
Default Value 0
Related Service Mode COPIER> OPTION> FEED-SW> EVLP-SPD
Amount of Change per
Unit
1
TFL-RTC 1 Set delvry dest at rcvry after tray full
Detail To select the delivery destination for a job with multiple pages after recovering the Delivery Tray
that reaches the full level.
When 0 is set, a job is output from the delivery destination again from which the last job was
delivered.
When 1 is set, a job is output from the delivery destination which priority is set as high at "Output
Tray Settings" in Settings/Registration menu.
Use Case When changing the delivery tray
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Output from the tray from which the last job was output, 1: Output from the delivery destination
which priority is high among the delivery trays
Default Value 0
Additional Functions
Mode
Function Settings> Common> Paper Output Settings> Output Tray Settings
USZ-FEED 1 [Not used]
■ IMG-SPD
COPIER > OPTION > IMG-SPD
FX-D-TMP 1 Set of down sequence start temperature
Detail To set a temperature to start the down sequence control when overheating occurs on the edge of
the Fixing Film.
As the value is changed by 1, the temperature is changed by 5 deg C from the initial setting
temperature.
Use Case - When fixing offset occurs on the edge of paper
- Upon user's request (to improve productivity)
Adj/Set/Operate Method 1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range -4 to 4
-4: -20 deg C, -3: -15 deg C, -2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C, 3:
+15 deg C, 4: +20 deg C
Unit deg C
Default Value 0
Amount of Change per
Unit
5
8. Service Mode
943